Discussion
Home ‣ Technical Drawing ‣ Dimensioning See What Others Are Saying!
- Question
The maximum and minimum sizes of a feature are identified by a ________ tolerance.
Options- A. Limits
- B. GD&T
- C. reference
- D. allowance
- Correct Answer
- Limits
- 1. Piping may also be shown in orthographic projection.
Options- A. True
- B. False Discuss
- 2. Generally, hidden lines should be omitted in auxiliary views.
Options- A. True
- B. False Discuss
- 3. This type of pipe is commonly used for water or gas service, and also as soil pipe:
Options- A. PVC
- B. Copper
- C. Steel
- D. Cast-iron Discuss
- 4. When creating a block the drafter should carefully draw it in the 0 layer.
Options- A. True
- B. False Discuss
- 5. The visible lines adjacent to a revolved section may be broken out if desired.
Options- A. True
- B. False Discuss
- 6. ANSI has established three classes of fit.
Options- A. True
- B. False Discuss
- 7. Solids are bounded by the surfaces that contain them.
Options- A. True
- B. False Discuss
- 8. A metric dimension that is a whole number does not show a decimal point or a zero.
Options- A. True
- B. False Discuss
- 9. Quarter sections expose the interior of one half of the object and the exterior of the other half.
Options- A. True
- B. False Discuss
- 10. This type of solid has a polygon for a base and triangular lateral faces that intersect at a vertex:
Options- A. Pyramid
- B. Prism
- C. Cone
- D. Torus Discuss
More questions
Correct Answer: True
Correct Answer: True
Correct Answer: Cast-iron
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: Pyramid
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.