logo

CuriousTab

CuriousTab

Discussion


Home Technical Drawing Dimensioning Comments

  • Question
  • This is used to indicate that a surface is to be machined:


  • Options
  • A. Finish mark
  • B. Machining mark
  • C. Roughness indicator
  • D. Coordinate mark

  • Correct Answer
  • Finish mark 


  • Dimensioning problems


    Search Results


    • 1. The ________ tool on the Dimension tool bar places the length of an arch on a drawing.

    • Options
    • A. Arc Radius
    • B. Arc Length
    • C. Radius
    • D. Diameter
    • Discuss
    • 2. This is the total amount that the feature on the actual part is allowed to vary from what is specified by the dimension:

    • Options
    • A. Allowance
    • B. Tolerance
    • C. Specification
    • D. Difference
    • Discuss
    • 3. This is a thin solid line directing attention to a note or dimension and starting with an arrowhead or dot:

    • Options
    • A. Dimension line
    • B. Extension line
    • C. Leader
    • D. Specification
    • Discuss
    • 4. Baseline dimensions are referenced from a common geometric feature known as a ________.

    • Options
    • A. edge
    • B. corner
    • C. datum
    • D. point of reference
    • Discuss
    • 5. This is a line terminated by arrowheads, indicating the direction and extent of a dimension:

    • Options
    • A. Dimension line
    • B. Extension line
    • C. Arrowhead line
    • D. Centerline
    • Discuss
    • 6. One way to evenly space dimensions on a drawing is to use the ________.

    • Options
    • A. Dimension Space tool
    • B. Linear tool
    • C. Continue tool
    • D. Baseline tool
    • Discuss
    • 7. The condition of a part when it contains the least amount of material is referred to as ________.

    • Options
    • A. smallest
    • B. LMC
    • C. MMC
    • D. actual size
    • Discuss
    • 8. A circular arc is dimensioned in the view where you see its true shape by giving the value for its:

    • Options
    • A. Diameter
    • B. Arc length
    • C. Radius
    • D. Chord length
    • Discuss
    • 9. The maximum and minimum sizes of a feature are identified by a ________ tolerance.

    • Options
    • A. Limits
    • B. GD&T
    • C. reference
    • D. allowance
    • Discuss
    • 10. Placement of dimensions on a drawing is controlled by ________.

    • Options
    • A. ANSI
    • B. The design engineer
    • C. Corporate drafting standards
    • D. All of the above
    • Discuss


    Comments

    There are no comments.

Enter a new Comment