Discussion
Home ‣ Technical Drawing ‣ Sectional Views Comments
- Question
This type of section is limited by a break line:
Options- A. Removed section
- B. Revolved section
- C. Broken-out section
- D. Half section
- Correct Answer
- Broken-out section
- 1. A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.
Options- A. Offset
- B. half
- C. whole
- D. broken out Discuss
- 2. These breaks are used to shorten the view of an object:
Options- A. Section breaks
- B. Aligned breaks
- C. Conventional breaks
- D. Full breaks Discuss
- 3. In this type of section, one quarter of the object is removed:
Options- A. Revolved section
- B. Removed section
- C. Quarter section
- D. Half section Discuss
- 4. Objects that are symmetric can be shown effectively using this type of section:
Options- A. Quarter section
- B. Half section
- C. Full section
- D. Symmetric section Discuss
- 5. When filling an area with a hatch pattern in AutoCAD the drafter needs to be able to ________.
Options- A. see the entire bounding area to hatch
- B. set Ortho on
- C. turn ISO grid off
- D. set the layer to Defpoints Discuss
- 6. By using a ________ section of a cylindrical mechanical part the drafter should be able to show only one view of the part.
Options- A. half
- B. whole
- C. revolved
- D. broken out Discuss
- 7. When only a small section of an interior area needs to be revealed the drafter can use a ________ section.
Options- A. half
- B. quarter
- C. full
- D. broken out Discuss
- 8. The section view drawing in which one fourth of an object has been marked for removal is known as a ________ section.
Options- A. full
- B. half
- C. quarter
- D. none of the above Discuss
- 9. In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________.
Options- A. leave the view as is
- B. eliminate the view
- C. use the left view instead
- D. none of the above Discuss
- 10. The type of line that projects from an object for the express purpose of locating a dimension is a ________ line.
Options- A. visible
- B. hidden
- C. extension
- D. dimension Discuss
Sectional Views problems
Search Results
Correct Answer: Offset
Correct Answer: Conventional breaks
Correct Answer: Half section
Correct Answer: Half section
Correct Answer: see the entire bounding area to hatch
Correct Answer: revolved
Correct Answer: broken out
Correct Answer: half
Correct Answer: eliminate the view
Correct Answer: extension
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.