Discussion
Home ‣ Technical Drawing ‣ Sectional Views See What Others Are Saying!
- Question
A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.
Options- A. Offset
- B. half
- C. whole
- D. broken out
- Correct Answer
- Offset
- 1. Short dashed lines can be used to illustrate a visible feature.
Options- A. True
- B. False Discuss
- 2. Tolerance issues are primarily a concern in manufacturing rather than in the design and drafting process.
Options- A. True
- B. False Discuss
- 3. The position of the observer's eye is called the station point.
Options- A. True
- B. False Discuss
- 4. It is more difficult to manufacture a part designed using two decimal places than the same part using four decimal places.
Options- A. True
- B. False Discuss
- 5. Hatchures are short, parallel, or slightly divergent lines drawn in the direction of a slope.
Options- A. True
- B. False Discuss
- 6. Drafters are often expected to follow the drafting standards as set in the ASME Y14.5M-1994 publication.
Options- A. True
- B. False Discuss
- 7. A single-curved surface is a developable ruled surface that can be unrolled to coincide with a cylinder.
Options- A. True
- B. False Discuss
- 8. The major diameter is the largest diameter of a screw thread.
Options- A. True
- B. False Discuss
- 9. Knurl is a pattern form on a surface to provide for better gripping or more surface area for attachment.
Options- A. True
- B. False Discuss
- 10. The bearing of a line is its angle from magnetic south.
Options- A. True
- B. False Discuss
More questions
Correct Answer: False
Correct Answer: False
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: False
Correct Answer: True
Correct Answer: True
Correct Answer: False
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.