Discussion
Home ‣ Technical Drawing ‣ Sectional Views Comments
- Question
Objects that are symmetric can be shown effectively using this type of section:
Options- A. Quarter section
- B. Half section
- C. Full section
- D. Symmetric section
- Correct Answer
- Half section
- 1. When filling an area with a hatch pattern in AutoCAD the drafter needs to be able to ________.
Options- A. see the entire bounding area to hatch
- B. set Ortho on
- C. turn ISO grid off
- D. set the layer to Defpoints Discuss
- 2. In the section view, the areas that would have been in actual contact with the cutting plane are shown with:
Options- A. A cutting plane line
- B. Section lining
- C. Visible lines
- D. Lines and arrows Discuss
- 3. In offset sections, offsets or bends in the cutting plane are all:
Options- A. 90 degrees
- B. 180 degrees
- C. Either 90 or 180 degrees
- D. 30, 60, or 90 degrees Discuss
- 4. Drafters should use a ________ in a section view of a mechanical part that includes the cylindrical view of a threaded hole.
Options- A. Center line
- B. Hatch line
- C. Poly line
- D. Dimension line Discuss
- 5. When creating a Cutting Plane line with AutoCAD it is customary to use a ________ to create the line.
Options- A. center line
- B. polyline
- C. dashed line
- D. hatch line Discuss
- 6. In this type of section, one quarter of the object is removed:
Options- A. Revolved section
- B. Removed section
- C. Quarter section
- D. Half section Discuss
- 7. These breaks are used to shorten the view of an object:
Options- A. Section breaks
- B. Aligned breaks
- C. Conventional breaks
- D. Full breaks Discuss
- 8. A ________ section allows the drafter to create a Cutting Plane line which is not in a straight line across the part.
Options- A. Offset
- B. half
- C. whole
- D. broken out Discuss
- 9. This type of section is limited by a break line:
Options- A. Removed section
- B. Revolved section
- C. Broken-out section
- D. Half section Discuss
- 10. By using a ________ section of a cylindrical mechanical part the drafter should be able to show only one view of the part.
Options- A. half
- B. whole
- C. revolved
- D. broken out Discuss
Sectional Views problems
Search Results
Correct Answer: see the entire bounding area to hatch
Correct Answer: Section lining
Correct Answer: 90 degrees
Correct Answer: Center line
Correct Answer: polyline
Correct Answer: Half section
Correct Answer: Conventional breaks
Correct Answer: Offset
Correct Answer: Broken-out section
Correct Answer: revolved
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.