Discussion
Home ‣ Technical Drawing ‣ Sectional Views Comments
- Question
When creating a Cutting Plane line with AutoCAD it is customary to use a ________ to create the line.
Options- A. center line
- B. polyline
- C. dashed line
- D. hatch line
- Correct Answer
- polyline
- 1. In architectural drawing ________ are often used to illustrate and detail structural components.
Options- A. Foundation beam detail sections
- B. Wall sections
- C. Building sections
- D. All of the above Discuss
- 2. To avoid having to dimension to a hidden feature the drafter can utilize a ________ section.
Options- A. whole
- B. half
- C. broken out
- D. all of the above Discuss
- 3. The ________ is a standard element of a section view in a technical drawing.
Options- A. Cutting Plane line
- B. Section lines
- C. Material hatch pattern
- D. All of the above Discuss
- 4. This type of section is not in direct projection from the view containing the cutting plane:
Options- A. Revolved section
- B. Removed section
- C. Broken-out section
- D. Full section Discuss
- 5. This is the plane upon which the top view is projected:
Options- A. Horizontal
- B. Frontal
- C. Profile
- D. Base Discuss
- 6. Drafters should use a ________ in a section view of a mechanical part that includes the cylindrical view of a threaded hole.
Options- A. Center line
- B. Hatch line
- C. Poly line
- D. Dimension line Discuss
- 7. In offset sections, offsets or bends in the cutting plane are all:
Options- A. 90 degrees
- B. 180 degrees
- C. Either 90 or 180 degrees
- D. 30, 60, or 90 degrees Discuss
- 8. In the section view, the areas that would have been in actual contact with the cutting plane are shown with:
Options- A. A cutting plane line
- B. Section lining
- C. Visible lines
- D. Lines and arrows Discuss
- 9. When filling an area with a hatch pattern in AutoCAD the drafter needs to be able to ________.
Options- A. see the entire bounding area to hatch
- B. set Ortho on
- C. turn ISO grid off
- D. set the layer to Defpoints Discuss
- 10. Objects that are symmetric can be shown effectively using this type of section:
Options- A. Quarter section
- B. Half section
- C. Full section
- D. Symmetric section Discuss
Sectional Views problems
Search Results
Correct Answer: All of the above
Correct Answer: all of the above
Correct Answer: All of the above
Correct Answer: Removed section
Correct Answer: Horizontal
Correct Answer: Center line
Correct Answer: 90 degrees
Correct Answer: Section lining
Correct Answer: see the entire bounding area to hatch
Correct Answer: Half section
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.