Discussion
Home ‣ Technical Drawing ‣ Orthographic Projection See What Others Are Saying!
- Question
The top, front, and bottom views align in this manner:
Options- A. Horizontally
- B. Vertically
- C. According to the planar views
- D. Parallel to the frontal plane
- Correct Answer
- Vertically
- 1. Welding is often more expensive when only one or a few identical parts are required.
Options- A. True
- B. False Discuss
- 2. Symbols should conform to an internationally or nationally approved standard.
Options- A. True
- B. False Discuss
- 3. These types of pipes are generally connected with bell and spigot joints or flanged joints:
Options- A. Soil and waste
- B. Water and gas
- C. Water and steam
- D. Gas and soil Discuss
- 4. To insure that everyone understands what the electrical symbols represent it is customary to include a ____ on the electrical sheet.
Options- A. list
- B. part number
- C. electrical legend
- D. electrical layer Discuss
- 5. Once the architect has finalized the house plans with the client any changes to the design requested by the client will require a ________.
Options- A. change order
- B. modification slip
- C. whole new set of drawings
- D. none of the above Discuss
- 6. An intersection drawing is a flat representation or pattern that, when folded together, creates a 3D object.
Options- A. True
- B. False Discuss
- 7. This type of drawing shows two lines representing the pipe diameter:
Options- A. Single-line
- B. Double-line
- C. Standard piping
- D. Centerline piping Discuss
- 8. Some common blocks used by architectural drafters include ________.
Options- A. door swings
- B. ceiling fans
- C. appliances
- D. All of the above Discuss
- 9. When drawing a line using the relative coordinate system a line is created from ________.
Options- A. 0,0
- B. the ending point of the last line
- C. the beginning point of the last line
- D. none of the above Discuss
- 10. In order to set drawing limits for a "C" size architectural drawing the drafter should set the limits to ________.
Options- A. 0,0 and 2,9
- B. 0,0 and 17,11
- C. 0,0 and 18,24
- D. 0,0 and 34,24 Discuss
More questions
Correct Answer: False
Correct Answer: True
Correct Answer: Water and gas
Correct Answer: electrical legend
Correct Answer: change order
Correct Answer: False
Correct Answer: Double-line
Correct Answer: All of the above
Correct Answer: the ending point of the last line
Correct Answer: 0,0 and 18,24
Comments
There are no comments.More in Technical Drawing:
Architectural Working DrawingsAuxiliary ViewsAxonometric ProjectionBlocksComputer Aided Design BasicsDimensioningDimensioning Architectural DrawingsDrawing ManagementElectronic DiagramsGears and CamsGraphic Language for DesignIsometric DrawingsLandform DrawingsLayouts and LetteringManufacturing ProcessesMechanical Working DrawingsMultiview DrawingOblique ProjectionOrthographic ProjectionPerspective DrawingsPiping DrawingsSectional ViewsStructural DrawingTechnical SketchingThreads, Fasteners and Springs3D Modeling BasicsTolerancingTraditional Drafting Techniques2D Drawing RepresentationWelding RepresentationWorking DrawingsProgramming
Copyright ©CuriousTab. All rights reserved.