logo

CuriousTab

CuriousTab

Discussion


Home Technical Drawing Layouts and Lettering See What Others Are Saying!
  • Question
  • When lettering a CAD drawing, for clarity you should limit the number of fonts to:


  • Options
  • A. One
  • B. Two
  • C. Three
  • D. Any number

  • Correct Answer
  • Two 


  • More questions

    • 1. Monuments marking surveying points are typically not intended to be permanent.

    • Options
    • A. True
    • B. False
    • Discuss
    • 2. Plastic pipe is lightweight and corrosionproof, but typically is not resistant to chemicals.

    • Options
    • A. True
    • B. False
    • Discuss
    • 3. The Offset command can be used on vertical lines but not on horizontal lines.

    • Options
    • A. True
    • B. False
    • Discuss
    • 4. The primary difference between isometric drawings and perspective drawings is that in an isometric drawing both vertical and horizontal lines remain parallel while in a perspective drawing both horizontal and vertical lines are in line with an apparent vanishing point.

    • Options
    • A. True
    • B. False
    • Discuss
    • 5. The center line of a hidden cylinder feature appearing in the front view should line up with the center mark in the corresponding circle which appears in the auxiliary view.

    • Options
    • A. True
    • B. False
    • Discuss
    • 6. When dimensioning piping drawings, you give the lengths of all runs of this type:

    • Options
    • A. Straight
    • B. Angular
    • C. Filleted
    • D. Transverse
    • Discuss
    • 7. In working drawings for worm gears, gear teeth are omitted and the gear blank is represented conventionally.

    • Options
    • A. True
    • B. False
    • Discuss
    • 8. This allows the designer to conceptualize objects more easily without having to make costly illustrations, models, or prototypes:

    • Options
    • A. Computer-aided manufacturing
    • B. Computer-aided design
    • C. Computer-aided engineering
    • D. Computer-aided prototyping
    • Discuss
    • 9. In oblique sketches, the most commonly used angles for receding lines are:

    • Options
    • A. 15 or 30 degrees
    • B. 25 or 30 degrees
    • C. 30 or 45 degrees
    • D. 45 or 60 degrees
    • Discuss
    • 10. When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.

    • Options
    • A. Linear dimension
    • B. Aligned dimension
    • C. Baseline dimension
    • D. Angle dimension
    • Discuss


    Comments

    There are no comments.

Enter a new Comment