Discussion
Home ‣ Technical Drawing ‣ Layouts and Lettering Comments
- Question
This type of projection is when projectors are parallel to each other, but are at an angle other than 90 degrees to the plane of projection:
Options- A. Oblique projection
- B. Perpendicular projection
- C. Aesthetic projection
- D. Angular projection
- Correct Answer
- Oblique projection
- 1. Several of the tools used in traditional drafting include the following:
Options- A. Parallel straight edge
- B. 45 degree triangle
- C. Circle template
- D. All of the above Discuss
- 2. The first step in creating a traditional technical drawing is to ________.
Options- A. draw a series of guide lines
- B. set up the miter line
- C. align the paper so that it will be positioned square to the parallel bar
- D. sharpen the leads in the technical pens Discuss
- 3. Referring to the fractional inches to decimal inches to millimeter conversion chart on page 55 what is the equivalent mm measurement of 3/16 inch.
Options- A. 1.906
- B. 4.7625
- C. 5.958
- D. 14.6844 Discuss
- 4. Some traditional board drafters preferred the drafting machine over the parallel straight edge because it could be used without the need for________.
Options- A. circle templates
- B. triangles
- C. technical pens
- D. lettering guides Discuss
- 5. A civil engineer working on a bridge design would probably rely on his ________ scale for checking printed drawings.
Options- A. engineer's
- B. metric
- C. architect's
- D. none of the above Discuss
- 6. These units are based on inch-foot and yard measurements:
Options- A. International customary units
- B. U.S. metric units
- C. U.S. customary units
- D. ISO international units Discuss
- 7. There are two main types of projection:
Options- A. Parallel and Orthographic
- B. Station-point and Perspective
- C. Parallel and Convergent
- D. Perspective and Parallel Discuss
- 8. This is how axonometric, oblique, and perspective sketches show objects:
Options- A. Orthographically
- B. Pictorially
- C. Obliquely
- D. Parallel Discuss
- 9. When lettering a CAD drawing, for clarity you should limit the number of fonts to:
Options- A. One
- B. Two
- C. Three
- D. Any number Discuss
- 10. The primary unit of measurement for engineering drawings and design in the mechanical industries is the:
Options- A. Millimeter
- B. Centimeter
- C. Meter
- D. Kilometer Discuss
Layouts and Lettering problems
Search Results
Correct Answer: All of the above
Correct Answer: align the paper so that it will be positioned square to the parallel bar
Correct Answer: 4.7625
Correct Answer: triangles
Correct Answer: engineer's
Correct Answer: U.S. customary units
Correct Answer: Perspective and Parallel
Correct Answer: Pictorially
Correct Answer: Two
Correct Answer: Millimeter
Comments
There are no comments.More in Technical Drawing:
Programming
Copyright ©CuriousTab. All rights reserved.