Curioustab

Home » Digital Electronics » Digital System Projects Using HDL

In the keypad encoder, the ________ must hold in its current state until a key is released.

ring counter
MOD-6 counter
BCD counter
freeze bit

Correct Answer: ring counter

← Previous Question Next Question→

More Questions from Digital System Projects Using HDL

In the frequency counter, the length of time for the ________ to be enabled can be selected with the range select input.
The stepper motor HDL will ignore its counter inputs and pass control inputs directly to the output when set in mode ________.
The major blocks of the frequency counter are the counter, ________, decoder/display, and the timing and control unit.
In the digital clock project HDL code, the MOD-12 counter is using ________.
In the digital clock project, when it is 11:59:59, AND gate 1 detects that the tens of hours is 1 and the enable input is active. On the next clock pulse the AM/PM flip-flop will ________.
In the stepper motor, the half-step sequence is used when ________.
VARIABLES are considered to be updated ________ within a sequence of statements in a PROCESS, whereas SIGNALS referred to in a PROCESS are updated when the PROCESS ________.
One of the first steps in small-project management is to determine ________.
The step rate of the simulation of a stepper motor is probably ________ the actual stepper motor.
In the keypad encoder, the ring counter is implemented using ________ that responds to the clk input.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion