Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Digital Electronics
»
Digital System Projects Using HDL
One of the first steps in small-project management is to determine ________.
how many devices are controlled by the outputs
a way to test each block
if each block fits together
how each block works
Correct Answer:
how many devices are controlled by the outputs
← Previous Question
Next Question→
More Questions from
Digital System Projects Using HDL
The step rate of the simulation of a stepper motor is probably ________ the actual stepper motor.
In the keypad encoder, the ring counter is implemented using ________ that responds to the clk input.
The timing and control block provides the ________ for the frequency counter.
Using one case construct inside another is known as ________.
In the digital clock project, the 60 Hz signal is sent through a Schmitt-trigger circuit to produce square pulses at the rate of ________.
In the keypad encoder, the ________ activate(s) the freeze bit only when one column is low.
A very critical dimension in project management is ________.
The interface of the stepper motor needs to operate in one of ________ mode(s).
In the keypad encoder, just after the 4 ms mark, the simulation initiates the release of the key by changing the column value to ________, which causes the d output to go into its Hi-Z state.
In the digital clock design, the hours section is different from the seconds and minutes section in that it never goes to ________.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments