Curioustab

Home » Digital Electronics » Digital System Projects Using HDL

In the frequency counter, the length of time for the ________ to be enabled can be selected with the range select input.

display register
frequency prescaler
BCD counter
signal generator

Correct Answer: BCD counter

← Previous Question Next Question→

More Questions from Digital System Projects Using HDL

The stepper motor HDL will ignore its counter inputs and pass control inputs directly to the output when set in mode ________.
The major blocks of the frequency counter are the counter, ________, decoder/display, and the timing and control unit.
In the digital clock project HDL code, the MOD-12 counter is using ________.
In the digital clock project, when it is 11:59:59, AND gate 1 detects that the tens of hours is 1 and the enable input is active. On the next clock pulse the AM/PM flip-flop will ________.
In the stepper motor, the half-step sequence is used when ________.
VARIABLES are considered to be updated ________ within a sequence of statements in a PROCESS, whereas SIGNALS referred to in a PROCESS are updated when the PROCESS ________.
One of the first steps in small-project management is to determine ________.
The step rate of the simulation of a stepper motor is probably ________ the actual stepper motor.
In the keypad encoder, the ring counter is implemented using ________ that responds to the clk input.
The timing and control block provides the ________ for the frequency counter.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion