Curioustab

Home » Computer Science » Computer Hardware

To test for AC ripple on a PC power supply, you would set the volt/ohm meter for:

DC voltage scale
AC voltage
OHM scale
Farad scale
None of the above

Correct Answer: AC voltage

← Previous Question Next Question→

More Questions from Computer Hardware

On the 16-bit ISA bus, IRQ2 is elevated to which higher level interrupt?
What's the best way to prevent damaging your PC with static electricity?
Which component must be vacuumed or replaced during preventative maintenance on a laser printer?
When connecting two internal SCSI hard disks to a computer, where do you connect the second hard drive?
Match the device driver HIMEM.SYS to its operation.
How many devices can be used on a single SCSI bus? Keep in mind that the SCSI host adapter counts as a device.
Which of the following would be a logical first step in troubleshooting a PC?
On a dot matrix printer, you should never lubricate which part?
The digital multimeter is set for DC, Ohm and 20k. You will read _____ while measuring a good 2 amp fuse.
To install a second IDE drive into a computer, you must:

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion