Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Computer Science
»
Computer Hardware
A customer attached an external drive to his notebook computer but the computer is not recognizing it. What should be considered?
The cables are attached firmly
The external drive has been pre¬loaded with the appropriate software
The external drive was attached before the computer was on
The external drive is turned on
All of the above
Correct Answer:
All of the above
← Previous Question
Next Question→
More Questions from
Computer Hardware
In the Binary numbering system, a (1) represents a jumper being shorted and a (0) represents a jumper being open. On a three-bit jumper block on a SCSI drive, how would an ID of logical 3 be set?
The POST routine, which counts system board RAM first, is stored in:
A 6xx indicates a problem with the:
_____ help prevent power surges.
The ATAPI compliance is stands for?
Which common bus specification provides the fastest data transfer rate?
The ESD wrist strap is designed to protect PC Components or Service Technicians?
What is the paper feeding technology most commonly associated with dot-matrix printers?
Which monitor would provide the highest level of performance?
UART is a type of serial chip. Its letters stand for:
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments