In the estimate of design flood, Dickens assumes that high flood in cumecs, is proportional to catchment area raised to the power

More Questions from Water Resources Engineering

• Boston society of Civil Engineer's formula in cumecs/square km is based upon
• From the pattern of the rainfall shown in the below figure, the total precipitation is
• If the loss due to friction in pipes is 4 m, the total losses in strainer and bends may be taken as
• In estimating the rate of evaporation from the reservoir surface, a pan 1.5 metres in diameter, was filled upto 8.0 cm. During a specified period of time, the rainfall recorded was 5 cm. 3 cm of water was removed from the pan to keep the depth of water. At the end of the time, the depth was 9 cm. If the pan coefficient is 0.6, the evaporation loss is
• If the slope of a line for infiltration capacity curve is , the value of constant k in Horton's equation of infiltration capacity curve, is
• The radius of influence is
• The respective storm totals at three surrounding stations A, B and C are 110, 90 and 70 mm. If the normal annual precipitation amounts at stations X, A, B and C are respectively 1000, 1100, 1200 and 1250 mm, the estimated storm precipitation at X is
• Sharp crested weirs are generally used
• The area of a drainage basin whose axial length is 100 km is 2500 sq. km. Its form factor is
• Pick up the correct statement from the following :

Discussion & Comments