Curioustab

Home » Civil Engineering » Theory of Structures

The force in CD of the truss shown in given figure, is

3t compression
3t tension
zero
1.5t compression
1.5t tension

Correct Answer: zero

← Previous Question Next Question→

More Questions from Theory of Structures

The forces acting normally on the cross section of a bar shown in the given figure introduce
The deflection curve for the portal frame shown in the given figure is
Pick up the correct statement from the following:
Pick up the correct statement from the following:
A composite beam is composed of two equal strips one of brass and other of steel. If the temperature is raised
A short column (30 cm x 20 cm) carries a load P1 at 4 cm on one side and another load P2 at 8 cm on the other side along a principal section parallel to longer dimension. If the extreme intensity on either side is same, the ratio of P1 to P2 will be
The eccentricity (e) of a hollow circular column, external diameter 25 cm, internal diameter 15 cm for an eccentric load 100 t for non-development of tension, is
Maximum principal stress theory for the failure of a material at elastic point, is known
A steel plate d x b is sandwiched rigidly between two timber joists each D x B/2 in section. The moment of resistance of the beam for the same maximum permissible stress σ in timber and steel will be (where Young's modulus of steel is m times that of the timber).
A masonry dam (density = 20, 000 N/m3) 6 m high, one metre wide at the top and 4 m wide at the base, has vertical water face. The minimum stress at the base of the dam when the reservoir is full, will be

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion