Curioustab

Home » Civil Engineering » Structural Design Specifications

The minimum pitch i.e., the distance between centres of rivet holes is not less than

1.5 times the hole diameter
2.0 times the hole diameter
2.5 times the hole diameter
3.0 times the hole diameter
None of these.

Correct Answer: 2.5 times the hole diameter

← Previous Question Next Question→

More Questions from Structural Design Specifications

The value of fbct in the formula for calculating the thickness of a Rectangular base, according to IS : 800-1982, is
For heavily reinforced concrete member, the nominal maximum size of the aggregates should be restricted to
The concrete is deemed not to comply with the strength requirements if the strength is less than the greater of
In case of continuous beams, the distance between the points of zero moment, may be obtained as (where l is the effective span).
If a column is subjected to dead load and super imposed load only, the maximum ratio should not be greater than
The creep coefficient i.e. the ratio of ultimate creep and elastic strain after
The maximum deflection of a structure should not normally exceed lesser of the span/350 or
The depth 'd' of webs without horizontal stiffeners and consisting of tongue plates is taken lesser than the depth of the girder between the flanges less the sum of the depth of the tongue plates, and
The maximum area of compression reinforcement in a beam of cross section B x D is limited to
Pick up the correct statement regarding columns.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion