Curioustab

Home » Civil Engineering » Structural Design Specifications

The distance between, rivet line and the nearest edge of a joint not exposed to weather, is taken (where t is thickness in mm of the thinner outside plate).

6 t
8 t
10 t
12 t

Correct Answer: 12 t

← Previous Question Next Question→

More Questions from Structural Design Specifications

The minimum compressive strength on 15 cm cubes of M 30 grade concrete at 7 days, should be a minimum of
If D is the overall thickness of the slab, the diameter of the reinforcing bars should not exceed
The minimum pitch i.e., the distance between centres of rivet holes is not less than
The value of fbct in the formula for calculating the thickness of a Rectangular base, according to IS : 800-1982, is
For heavily reinforced concrete member, the nominal maximum size of the aggregates should be restricted to
The concrete is deemed not to comply with the strength requirements if the strength is less than the greater of
In case of continuous beams, the distance between the points of zero moment, may be obtained as (where l is the effective span).
If a column is subjected to dead load and super imposed load only, the maximum ratio should not be greater than
The creep coefficient i.e. the ratio of ultimate creep and elastic strain after
The maximum deflection of a structure should not normally exceed lesser of the span/350 or

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion