Curioustab

Home » Civil Engineering » Steel Structure Design

The tensile strength of mild steel for bolts and nuts should not be less than

32 kg/mm2
36 kg/mm2
40 kg/mm2
44 kg/mm2

Correct Answer: 44 kg/mm2

← Previous Question Next Question→

More Questions from Steel Structure Design

The maximum tensile and compressive bending stress in extreme fibres of rolled I-sections and channels on the effective section, is
Allowable working stress corresponding to the slenderness ratio of double angles placed back to back and connected to one side of a gusset plate, is reduced to
On eccentrically loaded columns, the equivalent axial load may be obtained by
If a pair of angles placed back to back in tension are connected by one leg of each angle, the net effective area of the section, is
The effective length of a double angle strut with angles placed back to back and connected to both the sides of a gusset plate, by not less than two rivets, is
Number of rivets required in a joint, is
The value of f.o.s 'm' in the formula for safe compressive stress for a column is taken as
The diameter of a bolt hole is taken as the nominal diameter of the bolt plus
For a cantilever beam of length L built-in at the support and restrained against torsion at the free end, the effective projecting length l is
The deflection of beams may be decreased by

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion