Curioustab

Home » Civil Engineering » RCC Structures Design

In the zone of R.C.C. beam where shear stress is less than 5 kg/cm2, nominal reinforcement is provided at a pitch of

one-half lever arm of the section
one-third lever arm of the section
lever arm of the section
one and half lever arm of the section.

Correct Answer: lever arm of the section

← Previous Question Next Question→

More Questions from RCC Structures Design

The zone in which transverse bending is likely to occur may be obtained by drawing a line from the faces of the column making an angle θ° with horizontal where θ° is
According to load factor method, the permissible load W on a short column reinforced with longitudinal bars and lateral stirrups, is
The minimum thickness of the cover at the end of a reinforcing bar should not be less than twice the diameter of the bar subject to a minimum of
Based on punching shear consideration, the overall depth of a combined footing under a column A, is
If T and R are the tread and rise of a stair which carries a load w per square metre on slope, the corresponding load per square metre of the horizontal area, is
A pre-cast pile generally used, is
If q is the punching shear resistance per unit area a, is the side of a square footing for a column of side b, carrying a weight W including the weight of the footing, the depth (D) of the footing from punching shear consideration, is
For the design of a simply supported T-beam the ratio of the effective span to the overall depth of the beam is limited to
Pick up the assumption for the design of a prestressed concrete member from the following :
A singly reinforced concrete beam of 25 cm width and 70 cm effective depth is provided with 18.75 cm2 steel. If the modular ratio (m) is 15, the depth of the neutral axis, is

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion