Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
RCC Structures Design
As per IS : 456, the reinforcement in a column should not be less than
0.5% and not more than 5% of cross-sec-tional area
0.6% and not more than 6% of cross-see-tional area
0.7% and not more than 7% of cross-sec-tional area
0.8% and not more than 8% of cross-sectional area
none of these.
Correct Answer:
0.8% and not more than 8% of cross-sectional area
← Previous Question
Next Question→
More Questions from
RCC Structures Design
In a singly reinforced beam
If P kg/m2 is the upward pressure on the slab of a plain concrete footing whose projection on either side of the wall is a cm, the depth of foundation D is given by
If the length of a combined footing for two columns l metres apart is L and the projection on the left side of the exterior column is x, then the projection y on the right side of the exterior column, in order to have a uniformly distributed load, is (where x is the distance of centre of gravity of column loads).
If L is the effective span of a R.C.C. beam which is subjected to maximum shear qmax at the ends, the distance from either end over which stirrups for the shear, are provided, is
A column is regarded as long column if the ratio of its effective length and lateral dimension, exceeds
In a cantilever retaining wall without a heel slab
A ribbed slab is provided for
Enlarged head of a supporting column of a flat slabs is technically .known as
If A is the area of the foundation of a retaining wall carrying a load W and retaining earth of weight w per unit volume, the minimum depth (h) of the foundation from the free surface of the earth, is
The width of the flange of a L-beam, should be less than
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments