Curioustab

Home » Civil Engineering » RCC Structures Design

The minimum thickness of the cover at the end of a reinforcing bar should not be less than twice the diameter of the bar subject to a minimum of

10 mm
15 mm
20 mm
25 mm
30 mm

Correct Answer: 25 mm

← Previous Question Next Question→

More Questions from RCC Structures Design

Based on punching shear consideration, the overall depth of a combined footing under a column A, is
If T and R are the tread and rise of a stair which carries a load w per square metre on slope, the corresponding load per square metre of the horizontal area, is
A pre-cast pile generally used, is
If q is the punching shear resistance per unit area a, is the side of a square footing for a column of side b, carrying a weight W including the weight of the footing, the depth (D) of the footing from punching shear consideration, is
For the design of a simply supported T-beam the ratio of the effective span to the overall depth of the beam is limited to
Pick up the assumption for the design of a prestressed concrete member from the following :
A singly reinforced concrete beam of 25 cm width and 70 cm effective depth is provided with 18.75 cm2 steel. If the modular ratio (m) is 15, the depth of the neutral axis, is
For a number of columns constructed in a rcjw, the type of foundation provided, is
If the ratio of long and short spans of a two way slab with corners held down is r, the actual reduction of B.M. is given by
As the percentage of steel increases

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion