Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Civil Engineering
»
RCC Structures Design
If a rectangular prestressed beam of an effective span of 5 meters and carrying a total load 3840 kg/m, is designed by the load balancing method, the central dip of the parabolic tendon should be
5 cm
10 cm
15 cm
20 cm
25 cm
Correct Answer:
10 cm
← Previous Question
Next Question→
More Questions from
RCC Structures Design
If the sides of a slab simply supported on edges and spanning in two directions are equal, the maximum bending moment is multiplied by
If the permissible compressive and tensile stresses in a singly reinforced beam are 50 kg/cm2 and 1400 kg/cm2 respectively and the modular ratio is 18, the percentage area At of the steel required for an economic section, is
If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than
For stairs spanning horizontally, the minimum waist provided is
The toe projection of foundation slabs is taken
The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than
If d is the diameter of a bar, ft is allowable tensile stress and fb, is allowable bond stress, the bond length is given by
If H is the overall height of a retaining wall retaining a surcharge, the width of the base slab usually provided, is
If the maximum bending moment of a simply supported slab is M Kg.cm, the effective depth of the slab is (where Q is M.R. factor)
If permissible working stresses in steel and concrete are respectively 1400 kg/cm2 and 80 kg/cm2 and modular ratio is 18, in a beam reinforced in tension side and of width 30 cm and having effective depth 46 cm, the lever arms of the section, is
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments