Curioustab

Home » Civil Engineering » RCC Structures Design

The toe projection of foundation slabs is taken

as one third of the base
as one sixth of overall height of the wall
equal to heel slab
below ground surface.

Correct Answer: as one third of the base

← Previous Question Next Question→

More Questions from RCC Structures Design

The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than
If d is the diameter of a bar, ft is allowable tensile stress and fb, is allowable bond stress, the bond length is given by
If H is the overall height of a retaining wall retaining a surcharge, the width of the base slab usually provided, is
If the maximum bending moment of a simply supported slab is M Kg.cm, the effective depth of the slab is (where Q is M.R. factor)
If permissible working stresses in steel and concrete are respectively 1400 kg/cm2 and 80 kg/cm2 and modular ratio is 18, in a beam reinforced in tension side and of width 30 cm and having effective depth 46 cm, the lever arms of the section, is
A pre-stressed concrete member
In a singly reinforced beam, if the permissible stress in concrete reaches earlier than that in steel, the beam section is called
In a combined footing if shear stress does not exceed 5 kg/cm2, the nominal stirrups provided are
An R.C.C beam of 25 cm width has a clear span of 5 metres and carries a U.D.L. of 2000 kg/m inclusive of its self weight. If the lever arm of the section is 45 cm., the beam is
Minimum spacing between horizontal parallel reinforcement of different sizes, should not be less than

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion