Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

for 90° elbow (medium radius) and 90°square elbow would be respectively around

25 and 60
3 and 5
100 and 250
250 and 600

Correct Answer: 25 and 60

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

For a 25 mm hole drilled in plates to be rivetted, the shank diameter of the rivet should be __________ mm.
In a shell and tube heat exchanger for a given heat transfer surface area, smaller diameter tubes are favoured as compared to larger diameter ones ; because the smaller diameter tubes
__________ closure is the weakest enclosure for cylindrical vessels.
In hydrostatic testing of welded pipe (for leakage, strength etc.) the ratio of minimum hydrostatic test pressure to internal design pressure is around
In a pressure vessel containing multiple openings of various dimensions at different parts, stress concentration at the edges of the opening is maximum which becomes negligibly small beyond the area covered by __________ times the hole diameter.
Pick out the wrong statement.
Which of the following efficiencies can be greater than 100%?
Elastic failure of a material occurs, when the tensile stress equals yield strength, yield point or the elastic limit. Also, the elastic failure occurs according to maximum strain theory, when the maximum tensile strain equals (where, σ = yield strength and E = modulus of elasticity)
Pick out the wrong statement.
for a Tee (used as elbow, entering run) would be around

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion