Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Chemical Engineering
»
Process Equipment and Plant Design
A pressure vessel is said to be made of 'thick' shell, if the ratio of its diameter to wall thickness is
10
10
20
20
Correct Answer:
10
← Previous Question
Next Question→
More Questions from
Process Equipment and Plant Design
Rate of filtrate delivery is inversely proportional to the
In a thin cylindrical shell, the hoop stress is __________ stress.
Which of the following factors determine the amount of entrainment in a distillation column?
"A claming section" before the liquid flows into the downcomer is privided to
In shell and tube heat exchangers, straight tie rods are used to
In actual operation of a bubble cap distillation tower, the __________ at the bottom of the tower is more than that at the top of the tower.
Apex angle of conical heads used in the bottom heads of chemical process equipments is usually
The absorption factor is defined as (where, S1 = slope of the equilibrium curve, S2 = slope of the operating line)
Nominal size of a pipe is an indication of its __________ diameter.
Pressure drop due to pipe fittings can be estimated by the equation, , where, Le = equivalent length of straight pipeline which will incur the same frictional loss as the fitting and D = diameter of the fitting. The value of (dimensionless) for 45° elbow and 180° close return bends would be respectively around
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments