Curioustab

Home » Chemical Engineering » Process Equipment and Plant Design

"A claming section" before the liquid flows into the downcomer is privided to

permit release of entrained vapour in the liquid.
reduce the discharge fluctuation.
ensure better vapour-liquid contact.
cool the liquid before it flows down.

Correct Answer: permit release of entrained vapour in the liquid.

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

In shell and tube heat exchangers, straight tie rods are used to
In actual operation of a bubble cap distillation tower, the __________ at the bottom of the tower is more than that at the top of the tower.
Apex angle of conical heads used in the bottom heads of chemical process equipments is usually
The absorption factor is defined as (where, S1 = slope of the equilibrium curve, S2 = slope of the operating line)
Nominal size of a pipe is an indication of its __________ diameter.
Pressure drop due to pipe fittings can be estimated by the equation, , where, Le = equivalent length of straight pipeline which will incur the same frictional loss as the fitting and D = diameter of the fitting. The value of (dimensionless) for 45° elbow and 180° close return bends would be respectively around
The retention time of material in a rotary dryer depends upon its
Hazards associated with the relief valve leakage for extremely hazardous material storage can be taken care of by providing
The difficulty of liquid distribution in packed towers is accentuated, when the ratio of tower diameter to packing diameter is
The normal range of velocity of steam in pipes is __________ m/sec.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion