Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Chemical Engineering
»
Process Equipment and Plant Design
Apex angle of conical heads used in the bottom heads of chemical process equipments is usually
30°
45°
60°
75°
Correct Answer:
60°
← Previous Question
Next Question→
More Questions from
Process Equipment and Plant Design
The absorption factor is defined as (where, S1 = slope of the equilibrium curve, S2 = slope of the operating line)
Nominal size of a pipe is an indication of its __________ diameter.
Pressure drop due to pipe fittings can be estimated by the equation, , where, Le = equivalent length of straight pipeline which will incur the same frictional loss as the fitting and D = diameter of the fitting. The value of (dimensionless) for 45° elbow and 180° close return bends would be respectively around
The retention time of material in a rotary dryer depends upon its
Hazards associated with the relief valve leakage for extremely hazardous material storage can be taken care of by providing
The difficulty of liquid distribution in packed towers is accentuated, when the ratio of tower diameter to packing diameter is
The normal range of velocity of steam in pipes is __________ m/sec.
Circumferential (hoop) stress in a thin cylindrical vessel under internal pressure is __________ the longitudinal stress.
In the agitators, the power required will be changed with the increase of diameter of agitator (D) as
With increase in temperature drop (in a shell and tube heat exchanger), the LMTD correction factor, FT
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments