Home » Chemical Engineering » Process Equipment and Plant Design

A/an __________ is used for changing the direction of a pipeline.

elbow
union
flange
disc compensator

Correct Answer: elbow

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

Value of Peclet number = 0, is the representative of
Typical static submergence for bubble cap plate column operating at atmospheric pressure may be around
For turbulent flow (NRe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by(where, Q = fluid flow rate, ft3/sec.ρ = fluid density, lb/ft3 μ = fluid viscosity, centipoise Di = optimum inside pipe diameter, inches)
To avoid the tearing off the plate of an edge, the margin (i.e., the minimum distance from the centre of the rivet hole to the nearest edge of the plate) should be equal to
In the allocated cap area, bubble caps are generally arranged on equilateral triangular pitch. Number of caps fixed on a plate is with a
Heat transfer co-efficient for a horizontal condenser as compared to a vertical condenser operating under similar conditions is
Hoop (circumferential) stress induced in a thin walled 'Horton Sphere' used for the storage of liquid ammonia under pressure is
The wall thickness of thin cylindrical shell with hemispherical ends is __________ that of the spherical ends.
Normally, the length to diameter ratio of rotary dryers varies form 4 to 10 and for its economic operation, the number of transfer units (NTU) for such dryers varies from
Large process vessels operating under extreme temperature and pressure conditions are normally clad/ lined with materials like stainless steel, aluminium, nickel & its alloys, copper & its alloys and titanium. The cladding thickness is generally about __________ percent of the total thickness.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion