Home » Chemical Engineering » Process Equipment and Plant Design

Normally, the length to diameter ratio of rotary dryers varies form 4 to 10 and for its economic operation, the number of transfer units (NTU) for such dryers varies from

1.5-2.5
3.5-5.5
7.5-10.0
10-15

Correct Answer: 1.5-2.5

← Previous Question Next Question→

More Questions from Process Equipment and Plant Design

Large process vessels operating under extreme temperature and pressure conditions are normally clad/ lined with materials like stainless steel, aluminium, nickel & its alloys, copper & its alloys and titanium. The cladding thickness is generally about __________ percent of the total thickness.
The LMTD correction factor (FT) is defined as the
The clearance between two tubes in a shell and tube heat exchanger is known as 'ligament', whose minimum value is __________ the outside diameter of the tube, but in no case it should be less than 4.5 mm.
Stage efficiency for packed tower varies with the
The raio, is normally taken as
The ratio of the largest load in a test to the original cross-sectional area of the test specimen is called the __________ stress.
In a shell and tube heat exchanger, the shortest centre to centre distance between the adjacent tubes is
A certain pressure vessel manufacturer avoids doing reinforcements calculations for openings by always providing a reinforcing pad extending upto double the diameter of the opening and of the same material and thickness as that of the shell wall. If area compensation is accepted as a code guideline, his approach leads to safe design
Poisson's ratio of a material is the ratio of unit lateral strain to the unit axial elongation within its elastic limit. The value of Poisson's ratio for structural and pressure vessel steel may be taken as
In a multipass shell and tube heat exchanger, the problem of differential expansion between the shell and tube passes is taken care of by using a

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion