Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Chemical Engineering
»
Process Equipment and Plant Design
The wall thickness of thin cylindrical shell with hemispherical ends is __________ that of the spherical ends.
equal to
more than
less than
either (b) or (c); depends on maximum permissible internal pressure
Correct Answer:
more than
← Previous Question
Next Question→
More Questions from
Process Equipment and Plant Design
Normally, the length to diameter ratio of rotary dryers varies form 4 to 10 and for its economic operation, the number of transfer units (NTU) for such dryers varies from
Large process vessels operating under extreme temperature and pressure conditions are normally clad/ lined with materials like stainless steel, aluminium, nickel & its alloys, copper & its alloys and titanium. The cladding thickness is generally about __________ percent of the total thickness.
The LMTD correction factor (FT) is defined as the
The clearance between two tubes in a shell and tube heat exchanger is known as 'ligament', whose minimum value is __________ the outside diameter of the tube, but in no case it should be less than 4.5 mm.
Stage efficiency for packed tower varies with the
The raio, is normally taken as
The ratio of the largest load in a test to the original cross-sectional area of the test specimen is called the __________ stress.
In a shell and tube heat exchanger, the shortest centre to centre distance between the adjacent tubes is
A certain pressure vessel manufacturer avoids doing reinforcements calculations for openings by always providing a reinforcing pad extending upto double the diameter of the opening and of the same material and thickness as that of the shell wall. If area compensation is accepted as a code guideline, his approach leads to safe design
Poisson's ratio of a material is the ratio of unit lateral strain to the unit axial elongation within its elastic limit. The value of Poisson's ratio for structural and pressure vessel steel may be taken as
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments