Curioustab

More Questions from Process Control and Instrumentation

Process degree of freedom indicates __________ number of controllers to be used.
The transfer function of a pure dead time system with dead time τd is
Gas analysis is commonly done using the
Bimetallic thermometer vs. industrial mercury-in-glass: which characteristic is nearly the same b...
Robust choice of process parameters for conservative proportional gain: given Gp(s) = 10 * exp(−0...
Closed-loop stability condition: for a feedback control system to be stable, which statement is c...
Among P, PD, PI, and PID controllers, which one typically exhibits the maximum stabilising (settl...
Bimetallic thermometers: which mechanical element type is generally not used in their construction?
Measuring sludge flow: which device is generally not used for sludge flow rate measurement?
Instrument order identification: which of the following is not a second-order instrument?
Thermowell design for industrial temperature measurement: which surface/property is most desirable?
In a shell-and-tube heat exchanger control loop, the inlet temperature of the heating/cooling uti...
Thermocouple wire insulation: which material has the highest temperature rating?
Controller tuning criteria – selecting the most effective error-integral In process control (PID/...
Thermistors in instrumentation – typical applications Thermistors (NTC/PTC semiconductor resistor...
Diaphragm pressure sensor mechanics – dependence on diameter For a thin, circular diaphragm used ...
Stalagmometer (drop count method) A stalagmometer is primarily used to measure which property of ...
Second-order system – phase lag in frequency response For a standard underdamped second-order sys...
Zirconia oxygen probe in combustion monitoring A zirconia (zirconium dioxide, YSZ) probe installe...
Flow metering – device capable of measuring the largest flow rate Among the listed primary elemen...
Polarography (dropping mercury electrode) – application domain Polarograph-based analysis is prim...

Process degree of freedom indicates __________ number of controllers to be used.

Chemical Engineering Process Control and Instrumentation

Choose an option

A

the maximum
B

the minimum
C

both maximum and the minimum
D

nothing about the

Answer

Correct Answer: the maximum

← Previous Next Question →

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion