Home » Certification » CISCO Certification

What router command allows you to determine whether an IP access list is enabled on a particular interface?

show ip port
show access - lists
show ip interface
show access - lists interface

Correct Answer: show ip interface

Explanation:

Of the available choices only the show ip interface command will tell you which interfaces have access lists applied. show access - lists will not show you which interfaces have an access list applied.

← Previous Question Next Question→

More Questions from CISCO Certification

If you wanted to deny all Telnet connections to only network 192.168.10.0, which command could you use?
Which command would you use to apply an access list to a router interface?
What is the most common attack on a network today?
What command would you use to create an extended access list that stops host 172.16.10.1 fro telnetting to host 172.16.30.5?
What command would you use to set an access list on a VTY line?
Which command will allow you to see real - time translations on your router?
Which command will create a dynamic pool named Todd that will provide you with 30 global addresses?
When creating a pool of global address, which of the following can be used instead of the netmask command?
Which of the following is considered to be the inside hosts address after translation?
Your inside locals are not being translated to the inside global addresses. Which of the following commands will show you if your inside globals are allowed to use the NAT pool? ip nat pool Corp 198.18.41.129 198.18.41.134 netmask 255.255.255.248 ip nat inside source list 100 int pool Corp overload

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion