Curioustab

Home » Certification » CISCO Certification

What command would you use to create an extended access list that stops host 172.16.10.1 fro telnetting to host 172.16.30.5?

Correct Answer: access - list 110 deny tcp host 17216101 host 17216305 eq 23 access - list 110 permit ip any any

← Previous Question Next Question→

More Questions from CISCO Certification

What command would you use to set an access list on a VTY line?
Which command will allow you to see real - time translations on your router?
Which command will create a dynamic pool named Todd that will provide you with 30 global addresses?
When creating a pool of global address, which of the following can be used instead of the netmask command?
Which of the following is considered to be the inside hosts address after translation?
Your inside locals are not being translated to the inside global addresses. Which of the following commands will show you if your inside globals are allowed to use the NAT pool? ip nat pool Corp 198.18.41.129 198.18.41.134 netmask 255.255.255.248 ip nat inside source list 100 int pool Corp overload
Pat Address Translation is also called what?
What type of address translation can use only one address to allow thousands of hosts to be translated globally?
In thefollowing output, what type of NAT is being used? ip nat pool todd-nat 170.168.10,10 170.168.10.20 netmask 255.255.255.0
What is the frequency range of the IEEE 802.11g standard?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion