Curioustab

Home » Certification » CISCO Certification

When creating a pool of global address, which of the following can be used instead of the netmask command?

/ (slash notation)
prefix - length
no mask
block - size

Correct Answer: prefix - length

Explanation:

Instead of the netmask command, you can use the prefix-length length statement.

← Previous Question Next Question→

More Questions from CISCO Certification

Which of the following is considered to be the inside hosts address after translation?
Your inside locals are not being translated to the inside global addresses. Which of the following commands will show you if your inside globals are allowed to use the NAT pool? ip nat pool Corp 198.18.41.129 198.18.41.134 netmask 255.255.255.248 ip nat inside source list 100 int pool Corp overload
Pat Address Translation is also called what?
What type of address translation can use only one address to allow thousands of hosts to be translated globally?
In thefollowing output, what type of NAT is being used? ip nat pool todd-nat 170.168.10,10 170.168.10.20 netmask 255.255.255.0
What is the frequency range of the IEEE 802.11g standard?
You have finished physically installing an access point on the ceiling of your office. At a minimum, which parameter must be configured on the access point in order to allow a wireless client to operate on it?
Which encryption type does WPA2 use?
What is the maximum data rate for the 802.11g standard?
A wireless client cannot connect to an 802.11b/g BSS with a b/g wireless card. The client section of the access point does not list any active WLAN clients. What is a possible reason for this?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion