Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Take Free Test
Home
»
Computer Science
»
Computer Hardware
When connecting a ribbon cable to a connector, how do you know which direction to plug it in?
The red line in the cable goes to the highest pin number
The colored line in the cable goes to pin #1
It does not matter
The blue or red line in the cable goes away from the power connector
None of the above
Correct Answer:
The colored line in the cable goes to pin #1
← Previous Question
Next Question→
More Questions from
Computer Hardware
In which phase of the laser printing process is a positive charge placed on the paper to pull the toner from the print drum?
To install a second IDE drive into a computer, you must:
How many pins on a VGA?
After trying to unload a TSR, you get an error message saying that other TSRs were loaded after the one you tried to remove. Which of the following commands could you use to see the current load order?
Legacy NIC configuration (non–Plug and Play, no jumpers): When installing a network interface card that does not support Plug and Play and has no physical jumpers, which method is used to set the required IRQ (interrupt request) for the adapter?
Laser printer fuser maintenance: To prevent toner from sticking to a laser printer’s heated rollers, which substance is properly used as a release agent on the fuser mechanism?
Laser printing process (conditioning step): During the conditioning phase of a laser printer, a uniform charge of what magnitude and polarity is placed on the photosensitive drum?
PC startup configuration: When you change the system start-up boot sequence (for example, USB first, then SSD), which system area are you modifying?
Legacy drive setup workflow: After performing a low-level format on a hard drive, what is the next step to prepare the disk for use by the operating system?
ESD safety practice: For a conductive (ESD-safe) workbench, what is the best and correct ground reference to connect to for safe static discharge control?
Discussion & Comments
No comments yet. Be the first to comment!
Posting…
Name
Comment
Post Comment
Join Discussion
Discussion & Comments