Curioustab

Home » Computer Science » Computer Hardware

RTS stands for:

ready to start
ready to switch
request to send
request to scan
ready to set

Correct Answer: request to send

← Previous Question Next Question→

More Questions from Computer Hardware

When connecting a ribbon cable to a connector, how do you know which direction to plug it in?
In which phase of the laser printing process is a positive charge placed on the paper to pull the toner from the print drum?
To install a second IDE drive into a computer, you must:
How many pins on a VGA?
After trying to unload a TSR, you get an error message saying that other TSRs were loaded after the one you tried to remove. Which of the following commands could you use to see the current load order?
Legacy NIC configuration (non–Plug and Play, no jumpers): When installing a network interface card that does not support Plug and Play and has no physical jumpers, which method is used to set the required IRQ (interrupt request) for the adapter?
Laser printer fuser maintenance: To prevent toner from sticking to a laser printer’s heated rollers, which substance is properly used as a release agent on the fuser mechanism?
Laser printing process (conditioning step): During the conditioning phase of a laser printer, a uniform charge of what magnitude and polarity is placed on the photosensitive drum?
PC startup configuration: When you change the system start-up boot sequence (for example, USB first, then SSD), which system area are you modifying?
Legacy drive setup workflow: After performing a low-level format on a hard drive, what is the next step to prepare the disk for use by the operating system?

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion