Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Technical Drawing
»
Orthographic Projection
This line pattern is composed of three dashes, one long dash on each end with a short dash in the middle:
Object
Hidden
Center
Phantom
Correct Answer:
Center
← Previous Question
Next Question→
More Questions from
Orthographic Projection
This type of surface is tipped to all principal planes of projection and does not appear true size in any standard view:
This is the plane upon which the top view is projected:
In orthographic views, dashed lines represent features that would be hidden behind other surfaces.
The profile plane is the plane upon which the side view is projected.
A plane surface that is parallel to a plane of projection appears on edge as a straight line.
Usually screws, bolts, shafts, tubes, and other elongated parts are drawn in a vertical position in the front view.
If an edge is perpendicular to a plane of projection, it appears as a point.
The depth dimensions in the top and side views do not necessarily correspond.
If an angle is in an inclined plane, it may be projected either larger or smaller than the true angle depending on its position.
A plane surface always projects either on edge or as a surface in any view.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments