Curioustab

Home » Technical Drawing » Oblique Projection

In an oblique drawing, equally spaced partial circles may be used to show this:

Symbolic thread pitch
Ellipses
Cavalier drawings
Projection points

Correct Answer: Symbolic thread pitch

← Previous Question Next Question→

More Questions from Oblique Projection

If you are sketching an ellipse in an oblique drawing, you can block in the enclosing rectangle and sketch the ellipse tangent to its sides.
In general, all types of sections for isometric drawing may be applied to oblique drawing.
If a complicated pictorial is needed, it may be easier and more accurate to create a 3D model than an oblique drawing.
In an oblique drawing, when an angle is specified in degrees in a receding plane, you should convert the angle into circular measurements.
In oblique projections, one of the object's principal faces is parallel to the plane of projection.
When the receding lines are drawn to half size, the drawing is known as a cabinet projection.
In CAD, oblique drawings are difficult to create because you cannot use snap increments or draw similarly to drawing on grid paper.
In oblique projections, the projectors are perpendicular to each other but are not parallel to the plane of projection.
Circles, circular arcs, and other curved surfaces may be drawn using offset measurements.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion