Curioustab

Home » Technical Drawing » Oblique Projection

In a CAD system, you can draw an ellipse by specifying these:

The bounding lines
The midpoint and end points
The center and major and minor axes
The center and radius

Correct Answer: The center and major and minor axes

← Previous Question Next Question→

More Questions from Oblique Projection

When the receding lines are true length, and the projectors are at 45 degrees to the plane of projection, the oblique drawing is called this:
Oblique sections are useful to show this:
In oblique projection, important shapes should be in this position relative to the viewing plane:
In an oblique drawing, equally spaced partial circles may be used to show this:
If you are sketching an ellipse in an oblique drawing, you can block in the enclosing rectangle and sketch the ellipse tangent to its sides.
In general, all types of sections for isometric drawing may be applied to oblique drawing.
If a complicated pictorial is needed, it may be easier and more accurate to create a 3D model than an oblique drawing.
In an oblique drawing, when an angle is specified in degrees in a receding plane, you should convert the angle into circular measurements.
In oblique projections, one of the object's principal faces is parallel to the plane of projection.
When the receding lines are drawn to half size, the drawing is known as a cabinet projection.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion