Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Technical Drawing
»
Isometric Drawings
A round is a rounded surface on the ________ corner of a part.
inside
outside
radial
isoplane
Correct Answer:
outside
← Previous Question
Next Question→
More Questions from
Isometric Drawings
AutoCAD refers to isometric ellipses as ________.
Isometric drawings are often used by ________ to help illustrate complex designs.
In order to create an isometric circle to represent a hole through the top surface of a box, the drafter must insure that the correct isoplane has been selected by scrolling through the isoplanes using the ________ key.
The bounding box method for setting up an isometric drawing helps the drafter ________.
When creating an isometric drawing in AutoCAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line.
A fillet is a rounded surface on the ________ corner of a part.
Before starting an isometric drawing in AutoCAD the drafter needs to ________.
The Offset command can be used on vertical lines but not on horizontal lines.
The bounding box method for creating an isometric drawing works well in both traditional board drawing and in AutoCAD.
An isometric drawing is a type of technical drawing used to illustrate a mechanical part in true 3-dimensional form.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments