Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Technical Drawing
»
Computer Aided Design Basics
When drawing a line using the relative coordinate system a line is created from ________.
0,0
the ending point of the last line
the beginning point of the last line
none of the above
Correct Answer:
the ending point of the last line
← Previous Question
Next Question→
More Questions from
Computer Aided Design Basics
When setting up a mechanical drawing in AutoCAD the drafter should set the units to ________.
The UCS icon represents the intersection of the ________.
Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________.
When using the direct entry method to create a horizontal line exactly three inches long the drafter should ________ first.
One quick way to view the entire drawing area is to use the Zoom command by typing ________.
You cannot use the Offset Tool to enlarge the size of a circle.
The two principle components of a CAD system are the computer and the software used to create technical drawings.
UCS stands for User Coordinate System.
When beginning a new drawing in AutoCAD the default start-up layer will be the Defpoints layer.
The version of AutoCAD being used can be checked by reading top blue line or title bar located above the pull down menu bar.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments