Drawing a Straight Segment — Basic Input To create a straight line segment in AutoCAD, is the expected workflow simply to specify a start point and an end point (via mouse pick or coordinate entry), after which the software draws the segment between those points?

Introduction / Context:
The question evaluates understanding of AutoCAD's most fundamental geometry creation: the line segment. Mastering point specification methods (mouse, direct distance, absolute/relative coordinates) is essential before moving to more advanced commands and constraints.

Given Data / Assumptions:

• The user invokes the LINE tool or a similar command.
• Coordinate input can be via picks, typed distances and angles, or snaps.
• Ortho/polar tracking may be on or off; either way, two points define a unique straight segment.

Concept / Approach:
A straight line is fully defined by two points. AutoCAD prompts: Specify first point, then Specify next point. Additional segments can be chained by specifying subsequent points; pressing Enter or Esc ends the command. Accuracy relies on object snaps and numeric input rather than freehand motion.

Step-by-Step Solution:
1) Start the LINE command (toolbar, ribbon, or type LINE/L).2) Pick or enter the start point (e.g., 0,0).3) Pick or enter the end point (e.g., @100<0 to draw 100 units at 0 degrees).4) End the command or continue adding connected segments as needed.

Verification / Alternative check:
Use object snaps (END, MID, CEN) to anchor endpoints; query the resulting segment with LIST or DIST to confirm coordinates and length match the entered values.

Why Other Options Are Wrong:
“Incorrect” denies the core behavior. Requirements about polar tracking or entering length/angle first are optional methods, not mandatory steps for creating a line.

Common Pitfalls:
Not using snaps, leading to off-by-small-amounts; mixing units or angles; leaving polar tracking angles misconfigured, which can bias cursor movement unintentionally.

Final Answer:
Correct