Curioustab

Home » Technical Drawing » Auxiliary Views

In this type of view, the cutting plane line indicates both the location of the cutting plane and the direction of sight:

Removed section
Revolved section
Auxiliary section
Partial section

Correct Answer: Auxiliary section

← Previous Question Next Question→

More Questions from Auxiliary Views

An efficient method for trimming the corners on an auxiliary view is to use the ________.
A partial auxiliary view usually shows only features on the ________ of the inclined line and not any projection of other planes.
The lines used to create the auxiliary view should appear as ________ in the finished view.
The offset distance for the width (front to back) distance of the auxiliary view is the same distance of the ________ in the top view.
When using the descriptive geometry method to create an auxiliary view the drafter should ________.
This type of solid is formed by sweeping a shape along a linear path:
A secondary auxiliary view is a projection off of the ________.
When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.
In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
Circular shapes appear in this fashion when viewed at an angle other than 90 degrees:

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion