Production Engineering problems
- 1. With the same tool life, the maximum material per minute is removed by
Options- A. increasing the cutting speed
- B. decreasing the cutting speed
- C. increasing the depth of cut
- D. increasing the feed rate Discuss
Correct Answer: increasing the depth of cut
- 2. In which of the following machine, the work is usually rotated while the drill is fed into work?
Options- A. Sensitive drilling machine
- B. Radial drilling machine
- C. Gang drilling machine
- D. Deep hole drilling machine Discuss
Correct Answer: Deep hole drilling machine
- 3. The relation between the tool life (T) in minutes and cutting speed (V) in m/min is (where n = An exponent, which depends upon the tool and workpiece, and C = A constant)
Options- A. VnT = C
- B. VTn = C
- C. Vn/T = C
- D. V/Tn = C Discuss
Correct Answer: VTn = C
- 4. The operation of producing grooves around the periphery of a cylindrical or conical workpiece is called
Options- A. profile milling
- B. gang milling
- C. saw milling
- D. helical milling Discuss
Correct Answer: helical milling
- 5. In conventional milling, the cutting force tends to lift the work.
Options- A. True
- B. False Discuss
Correct Answer: True
- 6. The grinding wheel speed (surface speed in m/min) usually varies from
Options- A. 500 to 1000
- B. 1000 to 1500
- C. 1500 to 2000
- D. 2000 to 2500 Discuss
Correct Answer: 1500 to 2000
- 7. In oblique cutting of metals, the cutting edge of the tool is
Options- A. perpendicular to the workpiece
- B. perpendicular to the direction of tool travel
- C. parallel to the direction of tool travel
- D. inclined at an angle less than 90° to the direction of tool travel Discuss
Correct Answer: inclined at an angle less than 90° to the direction of tool travel
- 8. Up milling is also called conventional milling.
Options- A. Agree
- B. Disagree Discuss
Correct Answer: Agree
- 9. Ceramic tools has greater tool life than carbide tools.
Options- A. True
- B. False Discuss
Correct Answer: True
- 10. In drilling brass, a drill with
Options- A. zero helix angle is used
- B. low helix angle is used
- C. high helix angle is used
- D. any helix angle can be used Discuss
Correct Answer: low helix angle is used
More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.