Production Engineering problems
- 1. The tool made of cemented carbide wear out faster at
Options- A. slow speeds
- B. medium speeds
- C. fast speeds
- D. very fast speeds Discuss
Correct Answer: slow speeds
- 2. The lead screw of a lathe has __________ threads.
Options- A. single start
- B. double start
- C. multi-start
- D. any one of these Discuss
Correct Answer: single start
- 3. The cutting tool in a milling machine is mounted on
Options- A. spindle
- B. arbor
- C. column
- D. knee Discuss
Correct Answer: arbor
- 4. Drilling is an example of
Options- A. orthogonal cutting
- B. oblique cutting
- C. simple cutting
- D. uniform cutting Discuss
Correct Answer: oblique cutting
- 5. The lip angle of a single point tool is usually
Options- A. 20° to 40°
- B. 40° to 60°
- C. 60° to 80°
- D. none of these Discuss
Correct Answer: 60° to 80°
- 6. The work or surface speed for cylindrical grinding varies from
Options- A. 5 to 10 m/min
- B. 10 to 20 m/min
- C. 20 to 30 m/min
- D. 40 to 60 m/min Discuss
Correct Answer: 20 to 30 m/min
- 7. Side rake angle of a single point cutting tool is the angle
Options- A. by which the face of the tool is inclined towards back
- B. by which the face of the tool is inclined sideways
- C. between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of the tool
- D. between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base Discuss
Correct Answer: by which the face of the tool is inclined sideways
- 8. The correct sequence of tool materials in increasing order of their ability to retain their hot hardness is
Options- A. carbide, ceramic, cermet, borazon
- B. ceramic, carbide, borazon, cermet
- C. cermet, carbide, ceramic, borazon
- D. borazon, ceramic, carbide, cermet Discuss
Correct Answer: cermet, carbide, ceramic, borazon
- 9. The machining of titanium is difficult due to
Options- A. high thermal conductivity of titanium
- B. chemical reaction between tool and work
- C. low tool-chip contact area
- D. none of these Discuss
Correct Answer: low tool-chip contact area
- 10. The silicon carbide abrasive is chiefly used for grinding
Options- A. cemented carbide
- B. ceramic
- C. cast iron
- D. all of these Discuss
Correct Answer: all of these
More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.