Production Engineering problems
- 1. The cutting speed for drilling aluminium, brass and bronze with high speed steel drills varies from
Options- A. 10 to 20 m/min
- B. 18 to 30 m/min
- C. 24 to 45 m/min
- D. 60 to 90 m/min Discuss
Correct Answer: 60 to 90 m/min
- 2. A tool used to withdraw a drill from the sleeve is called
Options- A. drill remover
- B. drill puller
- C. drift
- D. drill drawer Discuss
Correct Answer: drift
- 3. Fixtures are used
Options- A. for holding and guiding the tool in drilling, reaming or tapping operations
- B. for holding the work in milling, grinding, planing or turning operations
- C. to check the accuracy of workpiece
- D. none of the above Discuss
Correct Answer: for holding the work in milling, grinding, planing or turning operations
- 4. The lip angle is the angle
Options- A. between the tool face and the ground end surface of flank
- B. made by the face of the tool and the plane parallel to the base of the cutting tool
- C. between the face of the tool and a line tangent to the machined surface at the cutting point
- D. none of the above Discuss
Correct Answer: between the tool face and the ground end surface of flank
- 5. Crater wear is mainly due to the phenomenon known as
Options- A. adhesion of metals
- B. oxidation of metals
- C. diffusion of metals
- D. all of these Discuss
Correct Answer: diffusion of metals
- 6. Flank wear depends upon the
Options- A. hardness of the work and tool material at the operating temperature
- B. amount and distribution of hard constituents in the work material
- C. degree of strain hardening in the chip
- D. all of these Discuss
Correct Answer: amount and distribution of hard constituents in the work material
- 7. The carbide tools operating at very low cutting speeds (below 30 m/min)
Options- A. reduces tool life
- B. increases tool life
- C. have no effect on tool life
- D. spoils the work piece Discuss
Correct Answer: reduces tool life
- 8. The abrasive recommended for grinding materials of low tensile strength is
Options- A. silicon carbide
- B. aluminium oxide
- C. sand stone
- D. diamond Discuss
Correct Answer: silicon carbide
- 9. The addition of lead, sulphur and phosphorus to low carbon steels, help to
Options- A. reduce built up edge
- B. break up chips
- C. improve machinability
- D. all of these Discuss
Correct Answer: all of these
- 10. The cutting fluid mostly used for machining steel is
Options- A. water
- B. soluble oil
- C. dry
- D. heavy oils Discuss
Correct Answer: soluble oil
More in Mechanical Engineering:
Programming
Copyright ©CuriousTab. All rights reserved.