CuriousTab
Search
CuriousTab
Home
Aptitude
Computer
C Programming
C# Programming
C++ Programming
Database
Java Programming
Networking
Engineering
Biochemical Engineering
Biochemistry
Biotechnology
Chemical Engineering
Civil Engineering
Computer Science
Digital Electronics
Electrical Engineering
Electronics
Electronics and Communication Engineering
Mechanical Engineering
Microbiology
Technical Drawing
GK
Current Affairs
General Knowledge
Reasoning
Data Interpretation
Logical Reasoning
Non Verbal Reasoning
Verbal Ability
Verbal Reasoning
Exams
AIEEE
Bank Exams
CAT
GATE
IIT JEE
TOEFL
Jobs
Analyst
Bank PO
Database Administrator
IT Trainer
Network Engineer
Project Manager
Software Architect
Soil Mechanics and Foundation Engineering problems
1. Pick up the correct statement from the following:
Options
A. The range of water content between the liquid limit and plastic limit, is called
plasticity index
.
B. The ratio of the liquid limit minus the natural water content to the plasticity index of soils, is called
consistency index
C. The ratio of natural water content minus its plastic limit to its plasticity index is called
liquidity index
D. The ratio between plasticity index and flow index (
i.e.
slope of flow curve in case of liquid limit), is called
toughness index
E. All the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: All the above.
2. The ratio of the weight of water to the weight of solids in a given mass of soil, is known
Options
A. porosity
B. specific gravity
C. void ratio
D. water content.
Show Answer
Scratch Pad
Discuss
Correct Answer: water content.
3. A flow net may be utilised for the determination of
Options
A. exit gradient
B. seepage
C. hydrostatic pressure
D. seepage pressure
E. all the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: all the above.
4. The neutral stress in a soil mass is
Options
A. force per neutral area
B. force per effective area
C. stess taken up by the pore water
D. stress taken up by solid particles.
Show Answer
Scratch Pad
Discuss
Correct Answer: stess taken up by the pore water
5. A triaxial shear test is prefered to direct shear test, because
Options
A. it can be performed under all three driange conditions with complete control
B. precise measurement of pore pressure and change in volume during test, is not posible
C. stress distribution on the failure plane, is non uniform
D. none of these.
Show Answer
Scratch Pad
Discuss
Correct Answer: it can be performed under all three driange conditions with complete control
6. A plane inclined at an angle ? to the horizontal at which the soil is expected to stay in the absence of any lateral support, is known as
Options
A. natural slope line
B. repose line
C. the ? line
D. all the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: all the above.
7. Pick up the correct statement from the following:
Options
A. The permeability of the coarse-grained soils may be reduced by grouting.
B. The process of injecting fluids (
i.e.
grouts) into the pores space of the soil, is called grouting.
C. The grouting increases the soil strength.
D. All the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: All the above.
8. A suspended particle falls through a height
H
cm in water in
t
minutes. If the viscosity of water is
?
and specific gravity of the particle is
G
, the diameter of the particle is (where
M
is a constant factor)
Options
A. 10
3
M
B. 10
4
M
C. 10
5
M
D. 10
2
M
Show Answer
Scratch Pad
Discuss
Correct Answer: 10
5
M
9. The bearing capacity of a soil depends upon
Options
A. size of the particles
B. shape of the particles
C. cohesive properties of particles
D. internal frictional resistance of particles
E. all the above.
Show Answer
Scratch Pad
Discuss
Correct Answer: all the above.
10. Pick up the correct statement from the following:
Options
A. When stress decreases, void, ratio decreases
B. When stress decreases, coefficient of permeability decreases
C. When stress decreases, coefficient of volume change decreases
D. When stress decreases void ratio, co-effi-cients of per-meability and volume change decrease.
Show Answer
Scratch Pad
Discuss
Correct Answer: When stress decreases void ratio, co-effi-cients of per-meability and volume change decrease.
First
22
23
24
...
25
..
26
27
Last
More in Civil Engineering:
Advanced Surveying
Airport Engineering
Applied Mechanics
Building Construction
Building Materials
Concrete Technology
Construction Management
Docks and Harbours
Elements of Remote Sensing
Engineering Economy
Estimating and Costing
GATE Exam Questions
Highway Engineering
Hydraulics
Irrigation
Railways
RCC Structures Design
SI Units
Soil Mechanics and Foundation Engineering
Steel Structure Design
Strength of Materials
Structural Design Specifications
Surveying
Theory of Structures
Tunnelling
UPSC Civil Service Exam Questions
Waste Water Engineering
Water Resources Engineering
Water Supply Engineering