Which command displays RIP routing updates?

Q: Which command displays RIP routing updates?

The debug ip rip command is used to show the Internet Protocol (IP) Routing Information Protocol (RIP) updates being sent and received on the router.

show ip route
debug ip rip
show protocols
debug ip route

Correct Answer: debug ip rip

Explanation:

The debug ip rip command is used to show the Internet Protocol (IP) Routing Information Protocol (RIP) updates being sent and received on the router.

← Previous Question Next Question→

More Questions from IP Routing

Which statement is true regarding classless routing protocols? The use of discontiguous networks is not allowed. The use of variable length subnet masks is permitted. RIPv1 is a classless routing protocol. IGRP supports classless routing within the same autonomous system. RIPv2 supports classless routing.
The Corporate router receives an IP packet with a source IP address of 192.168.214.20 and a destination address of 192.168.22.3. Looking at the output from the Corporate router, what will the router do with this packet? Corp#sh ip route [output cut] R 192.168.215.0 [120/2] via 192.168.20.2, 00:00:23, Serial0/0 R 192.168.115.0 [120/1] via 192.168.20.2, 00:00:23, Serial0/0 R 192.168.30.0 [120/1] via 192.168.20.2, 00:00:23, Serial0/0 C 192.168.20.0 is directly connected, Serial0/0 C 192.168.214.0 is directly connected, FastEthernet0/0
Which of the following statements are true regarding the command ip route 172.16.4.0 255.255.255.0 192.168.4.2? The command is used to establish a static route. The default administrative distance is used. The command is used to configure the default route. The subnet mask for the source address is 255.255.255.0.

Discussion & Comments

No comments yet. Be the first to comment!

Join Discussion