Curioustab
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Aptitude
General Knowledge
Verbal Reasoning
Computer Science
Interview
Home
»
Mechanical Engineering
»
Workshop Technology
The fullers are used
for finishing flat surfaces
for necking down a piece of work
for punching a hole
to finish the punched hole
Correct Answer:
for necking down a piece of work
← Previous Question
Next Question→
More Questions from
Workshop Technology
The cross-section of a chisel is usually
A plug gauge is used to check the diameter of shafts and studs.
The property of sand due to which it evolves a great amount of steam and other gases is called
In back-hand welding, the angle between the welding torch and the work is kept as
A saw which cuts wood during the return stroke of the saw is known as
In sheet metal blanking, shear is provided on punches and dies so that
The bloom is smaller than a billet.
In shielded arc welding
Surface plate is used to check the trueness of flat surfaces.
The ferrous metals require more machining allowance than non-ferrous metals.
Discussion & Comments
No comments yet. Be the first to comment!
Name:
Comment:
Post Comment
Join Discussion
Discussion & Comments